Event concerns Effectdecentral inputs The inputs are cyclically be read by the decentralized stationand the recent values are put at disposal.STOP ® RUN res. Pow-erONgeneral First the PII is deleted, then OB 100 is called. After the execu-tion of the OB, the BASP is reset and the cycle starts with:Delete PIO ® Read PII ® OB 1.decentral inputs The inputs are be read by the decentralized station and therecent values are put at disposal.RUN general The program is cyclically executed:Read PII ® OB 1 ® Write PIO.PII = Process image inputsPIO = Process image outputs4.12 Overall resetDuring the overall reset the entire user memory is erased. Data located in the memorycard is not affected. You have 2 options to initiate an overall reset:n Overall reset by means of the operating mode switchn Overall reset by means of the Siemens SIMATIC ManagerYou should always establish an overall reset to your CPU before loadingan application program into your CPU to ensure that all blocks have beencleared from the CPU.4.12.1 Overall reset by means of the operating mode switch1. Your CPU must be in STOP mode. For this switch the operating mode switch of theCPU to STOP.ð Status bar:2. Switch the operating mode switch to MR position for about 3 seconds.ð The yellow LED blinks with 1Hz and changes from repeatedblinking to permanently on.3. Place the operating mode switch in the position STOP and switch it to MR andquickly back to STOP within a period of less than 3 seconds.ð The overall reset is carried out. Here the yellow LED blinks with 2Hz.4. The overall reset has been completed when the yellow LED is on permanently.OverviewProceedingVIPA System MICRO Deployment CPU M13-CCF0000Overall reset > Overall reset by means of the operating mode switchHB400 | CPU | M13-CCF0000 | en | 16-47 75
