1 Spot Welding Application Using a Motor Gun1.3 Setting of Motor Gun1-51.3 Setting of Motor GunSet up the motor gun by following the procedures below. The dynamiccharacteristics of the motor gun need to be automatically identified by theMotor Gun Auto Turning function so that the pressurization is executed bythe optimum pressure torque instruction for the each motor gun.Before execution of Motor Gun Auto Turning function, proceduresdescribed in the chapters from chapter 1.3.1 "Posture of Motor Gun" tochapter 1.3.5 "Register the Base Position for Wear Detection (FixedSide)" are necessary.After execution of Motor Gun Auto Turning, register the base position forthe wear detection again because of the changes of the detectionaccuracy.Set the posture of the motor gunfor pressing downward(Refer to Chap. 1.3.1)Basic configration of Gun Condition file(Refer to Chap. 1.3.2)Setting of the conversion data frompulse to stroke(Refer to Chap. 1.3.3)Tentative setting ofthe conversion data from torque to pressure(Refer to Chap. 1.3.4)Setting of the conversion data from torque to pressure(Refer to Chap. 1.3.9)Register the base position forwear detection (fixed side)(Refer to Chap. 1.3.5)Register the base position forwear detection (fixed side)(Refer to Chap.1.3.5)Execution of Motor-Gun Auto Tuning(Refer to Chap. 1.3.6)Prepare for Motor-Gun Auto Tuning operation15 of 198
