1 Spot Welding Application Using a Motor Gun1.9 Manual Pressure1-751.9 Manual Pressure Manual pressure window1. GUN NO.Specifies the gun number to execute pressurization.2. PRESS MEASUREMENT MODESelect “ENABLE” when measuring the pressure with a force gauge.For the gun closing speed, just before the upper and lower tips to con-tact, the gun decreases its speed till the speed to the final touch speedspecified on GUN DETAIL SETTING window. When “ENABLE” is set to{PRESS MEASUREMENT MODE}, the gun’s position where it startsdecreasing the speed is offset for the distance equal to the thickness ofthe force gauge, and start decreasing the speed before the upper andlower tips contact the gauge. With this setting, measurement of thepressure with the same condition as the normal pressurization becomespossible.This mode is disabled when the mode is changed to play even if“ENABLE” is selected.3. THICKNESS FORCE GAUGESpecify the thickness of the force gauge to this item after “PRESS MEA-SUREMENT MODE” is enabled.4. ROBOT FOR PRESSURE/BEND COMPENSATIONSelect a robot for the pressure and bend compensation operations.5. TOUCH SPEEDSpecifies a touch speed when applying pressure manually.6. PRESS UNITShows the units for manual pressure. Select “N” or “% (TORQUE).”7. PRESSURESpecifies the pressure for manual pressure.12345678910111213141516NOTE The bend compensation is not executed by MANUAL DRYSPOT ([INTERLOCK] + [2]).85 of 198
