Yaesu FT-410 Operation Manual

Contents

Page 23FT-410 O peraTiOn ManualcW M Ode O peraTiOnu SiNG the b uilt- iN electroNic KeyerBefore starting, connect your keyer paddle to the front panel KEY jack in the status that turned off the [Power/ LOCK] switch.1. Press the []/[] buttons to select the operatingband.By pressing the [ ]/[ ] buttons, the operatingband will change as follows.7  10  14  15  18  21  24.5  28  1.8 3.5  7 ......2. Press the [MODE] buttons to select the CW mode.3. Rotate the [MAIN DIAL] knob to adjust theoperating frequency.If you use the MH-31 B8, you may adjust theoperating frequency by the [UP]/[DWN] buttons onthe microphone.4. Press the [VOX] button to engage automaticactivation of the transmitter when you close the CWkey. The “BK” icon will appear in the display.5. Press the [KEYER] button to activate the built-inElectronic Keyer.6. When you press either the “Dot” or “Dash” side ofyour paddle, the transmitter will automatically beactivated and the CW carrier will be transmitted.When your release the paddle, transmission willcease after a brief delay.nOTe :Do not use the plug except the 3.5-mm 3-pin type plug. If the plug in correct size is not used the radiomay be harmed or damaged.You may enable the CW keying by the [UP]/[DWN] keys ofthe MH-31B8 (while the built-in electronic keyer is engaged)via menu item “CW Keyer”.14.195.000M-012[MAIN DIAL] knob[MODE] button[▼]/[▲] button[KEYER] button[MENU] button[VOX] buttonA djuStiNG the K eyer Speed1. Press the [MENU] button to enter the Menu mode.The “Menu.” will appear on the display.2. Rotate the [MAIN DIAL] knob to select the menuitem “CW Speed”.3. Press the [GRP] button to enable adjustment of thismenu item.4. Rotate the [MAIN DIAL] knob while pressing eitherthe “Dot” or “Dash” side of your paddle, so as to setthe desired keyer speed (4 - 60 wpm).5. Press the [GRP] knob. The “Menu.” returns toappear continuously.6. Press the [MENU] button to save the new settingand return to normal operation.14.195.000M-012[MAIN DIAL] knob[MENU] button[GRP] button