Page 27FT-410 O peraTiOn ManualO peraTiOn On a lasKa e Mergency F requency: 5167.5 K Hz (u.s. v ersiOn O nly)Section 97.401(d) of the regulations governing amateur radio in the United States permit emergency amateurcommunications on the spot frequency of 5167.5 kHz by stations in (or within 92.6 km of) the state of Alaska.This frequency is only to be used when the immediate safety of human life and/or property are threatened,and is never to be used for routine communications.The FT-410 includes the capability for transmission and reception on 5167.5 kHz under such emergencyconditions.Preparation1. Press the [MENU] button to enter the Menu mode.The “Menu.” will appear on the display.2. Rotate the [MAIN DIAL] knob to select the menuitem “EMG”.3. Press the [GRP] knob to enable adjustment of thismenu item.4. Rotate the [MAIN DIAL] knob to select “ON”.5. Press the [GRP] button. The “Menu.” returns toappear continuously.6. Press the [MENU] button to save the new setting and return to normal operation.Operation1. Press the [V/M] button, if necessary, to enter the Memory mode. A memory channel number will appear indisplay.2. Press the [GRP] button to select the emergency channel (“EMG”).3. To exit from emergency channel and return to the VFO mode, just press the [V/M] button.Note: The receive-mode CLARIFIER functions normally while using this frequency, but variation of the transmitfrequency is not possible. Activation of “EMG” does not enable any other out-of-amateur-band capabilityon the transceiver. The full specifications of the FT-410 are not necessarily guaranteed on this frequency,but power output and receiver sensitivity should be fully satisfactory for the purpose of emergencycommunication. In an emergency, note that a half-wave dipole cut for this frequency should be approximately 45’3”on each leg (90’6” total length). Emergency operation on 5167.5 kHz is shared with the Alaska-FixedService. This transceiver is not authorized for operation, under the FCC’s Part 87, for aeronauticalcommunications.14.195.000M-012[MAIN DIAL] knob[V/M] button[MENU] button