Yaesu FT-4VR Advance Manual

Also see for FT-4VE: Operating manual

266 BELLSelects the number of CTCSS/DCS/PAGER/ARTS Bell ringer repetitions.OFF The beeper does not sound.1 T – 8 T The number of times the bell rings may be set from among 1to 8 times.CONT The bell continues to sound until performing key.7 CWIDTurns the CW Identifier ON/OFF during ARTS operation.TX OFF The CW ID does not transmit.TX ON The CW ID transmits.8 CW WRTPrograms and activates the CW Identifier (used during ARTS operation).See “CW Identifier Setup” for details.9 DC VLTDisplays battery DC voltage.10 DCS.CODSets the DCS CODE RX and TX.104 standard DCS codes are available. Default setting is 023 R (receive) / 023 T(Transmit).See “Setting the DCS CODE” for details.11 DT DLYSets the DTMF code transmission delay time.Set the transmission delay time of the registered DTMF code when set “AUTO”.50MS / 250MS /450MS / 750MS /1000MS (msec)While pressing and holding the PTT switch, press the numerickey, set the registered DTMF code delay time.12 DT SETSelect and edit the DTMF auto dialer memory channel.Up to 9 registers of 16-digit DTMF tone codes may be stored.For more details, see “DTMF Operation”.13 DT SPDSet the DTMF Autodialer Sending Speed.50MS High speed100MS Low speed