Yaesu FT-65R Operating Manual
Also see for FT-65E: Instruction manualOperating manualAdvance manualQuick manualQuick start guide
                                                    | |
Contents
| 
ScanningThe FT-65R/E makes available scanning of the stored memory channels, orscanning of the entire operating band, or scanning of a programmable subband portion. Scanning will halt when signals are encountered, and commu-nication may be initiated on that frequency.Operation is basically the same in each of the above scanning modes. Be-fore beginning, take a moment to select the way the scanning will resumeafter it halts on a signal.Setting the Scan-Resume TechniqueThree options for the Scan-Resume mode are available:Display DescriptionBUSY(default setting)In BUSY mode, the scanner will halt on a signal it en-counters. Scanning will resume one second after theother station signal ceases transmitting. In the caseof constant-carrier signals like Weather Station broad-casts, the scanner will likely remain on this frequencyindefinitely.HOLDIn HOLD mode, the scanner will halt on a signal it en-counters.Scanning will only resume when it is manually re-initiat-ed.TIMEIn TIME mode, the scanner will halt on a signal it en-counters, scanning will resume after five seconds evenif a signal is still on the frequency. To cancel scanning,press the the PTT switch, [▲] or [▼] key.1. Press and hold the F key to enter the Set mode.2. Press the [▲] or [▼] key to select Set Mode Item “25 RESUME”.3. Press the F key to enable adjustment of this Set Mode Items.4. Press the [▲] or [▼] key to select the desiredscan-resume mode.5. Press the PTT switch to save the setting andexit to normal operation.35FT-65R/FT-65E Operating Manual |
Related manuals for Yaesu FT-65E
manualsdatabase
Your AI-powered manual search engine