Yaesu FT-65R Operating Manual
Also see for FT-65E: Instruction manualOperating manualAdvance manualQuick manualQuick start guide
                                                    | |
Contents
| 
VFO ScanningThe FT-65R/E provides two VFO scanning functions: “Manual VFO Scan-ning” and “Programmed Mode (VFO) Scanning.”Manual VFO Scan1. If necessary, press the [ V/M] key to change to the VFO mode.2. Press and hold the [▲] or [▼] key to initiate upward or downward scanning,respectively.3. When scanning encounters a signal strong enough to open the squelch,the scanner will halt temporarily; the decimal point of the frequency displaywill blink to indicate this “Resuming” condition.4. The scanning will resume according to the Scan-Resume mode selected inthe Set Mode Item “25:RESUME”.5. To cancel scanning, press the PTT switch, [▲] or [▼] key.Programmed Mode (VFO) Scan1. Press and hold the [#BAND] key.2. Press the [▲] or [▼] key to select the band-width for Programmed Mode (VFO) scanner.Available selections are +-1 MHz, +-2 MHz, +-5 MHz, ALL, PMS-X, andBAND.Display DescriptionBAND(default setting)The scanner will sweep frequencies on the current op-erating band.+-1MHz The scanner will sweep ±1 MHz from the operating fre-quency.+-2MHz The scanner will sweep ±2 MHz from the operating fre-quency.+-5MHz The scanner will sweep ±5 MHz from the operating fre-quency.ALL The scanner will sweep all frequencies.PMS-XThe scanner will sweep frequencies designated by thecurrently selected PMS (Programmable Memory Scan)frequency pair.PMS-X will appear in the [#BAND] selections after setting aPMS frequency pair.36ScanningFT-65R/FT-65E Operating Manual |
Related manuals for Yaesu FT-65E
manualsdatabase
Your AI-powered manual search engine