Yaesu FT-65R Operating Manual
Also see for FT-65E: Instruction manualOperating manualAdvance manualQuick manualQuick start guide
                                                    | |
Contents
| 
TroubleshootingIf you suspect a malfunction, check the following items before requesting arepair.The transceiver does not turn on.• Is the battery depleted?• Charge the battery pack after purchase, and when the transceiver has notbeen used for a long time.• Is the battery pack properly attached?Refer to “Installing the Battery Pack” and securely mount the battery pack.There is no sound.• Is the squelch level (or S meter squelch) set too high?Press the MONI/T.CALL key and verify that you can hear white noise.Adjust the squelch level (or S meter squelch) when receiving a weak sig-nal.• Is the volume low?Rotate the PWR/VOL knob clockwise to increase the volume.• Is the tone squelch or DCS on?When the tone squelch or DCS is on, the sound is not output until thetransceiver receives a signal containing the same tone frequency or DCScode set.For more details on the DCS code, refer to the Advance Manual.There is no transmission of radio waves.• Are you pressing the PTT switch properly?• Is the PTT lock on?• Is the Busy TX Block (BCLO function) on?When the Busy TX Block (BCLO function) is on, transmission is inhibitedwhen receiving a signal, even if the PTT switch is pressed. Wait until thesignal being received stops and then press the PTT switch.• Is the transmission frequency on a ham radio band?Transmission cannot be performed on the FM Radio Broadcast Band/Infor-mation Radio Band.• Is the voltage of the battery pack correct?Check the remaining charge on the battery pack.In addition, using an inadequate power supply where voltage drops duringtransmission will prevent the FT-65R/E from operating at full capability.The keys or DIAL do not respond.• Is the Keypad Lock or PTT Lock on?43FT-65R/FT-65E Operating Manual |
Related manuals for Yaesu FT-65E
manualsdatabase
Your AI-powered manual search engine