MENU (SET) MODEYaesu FT-8800R Operating Manual (courtesy of W5JCK) Page 68 of 83Menu Quick Reference Table Some Menu item numbers or preceded by either the character b or h. Theb character denotes that the value for this Menu Item is to be appliedseparately for each Operating Band and/or Mode. The h characterdenotes that the value for this Menu Item is to be applied separately toeach Hyper Memory Channel.Item # Menu Function Available Values Default1 APO Selects the Automatic Power Off time. OFF, 0.5H – 12.0H OFFh 2 ARS Activates/deactivates the Automatic Repeater Shift feature. ON, OFF variesh 3 ARTS Selects the ARTS beep mode. IN RNG, ALWAYSh 4 BAND Enables/disables the VFO Band edge for the current band. BND ON, BNDOFF BND ON5 BEEP Enables/disables the beeper. BEP.ON, BEP.OFF BEP.ONb 6 CLK.SFT Shifts the CPU clock frequency. SFT.ON, SFT.OFF SFT.OFF7 CWID Enables/disables the CW identifier during ARTS operation. TX ON, TX OFF TX OFF8 CWID W Stores your callsign into the CW identifier.9 DIMMER Sets the Display brightness level. DIM 1, DIM 2, DIM 3,OFFDIM 1b 10 DCS.COD Sets the DCS code. 02311 DCS.N/R Selects Normal or Inverted DCS coding. TRX N, RX R, TX R,TRX RTRX Nh 12 DSP.SUB Selects the Sub Band display format. FREQ, CWID, DC-IN, OFFFREQ13 DTMF D Sets of the DTMF Autodialer Delay Time. 50MS, 250MS,450MS, 750MS,1000MS450MS14 DTMF S Sets of the DTMF Autodialer Sending Speed. 50MS, 75MS,100MS50MS15 DTMF W Loads the DTMF Autodialer Memories.16 HYPER Enables/disables the Automatic Writing feature for HyperMemory.MANUAL, AUTO MANUAL17 INET Selects the Internet Connection mode. INT.COD, INT.MEM INT.COD18 INET C Selects the Access Number (DTMF digit) for WIRES™operation.CODE 0 – 9,CODE A – FCODE 119 INET M Selects the Access Number (DTMF code) for non-WIRES™ Internet Link System access.d-1 – d-16 d-120 KEY.MOD Selects the key functions for the right band functionswitches.KEY1, KEY2 KEY1