Yaesu FT-8900R Operating Manual

Also see for FT-8900R: Brochure & specs Operating manual Technical supplement

Contents

SCANNINGYaesu FT-8900R Operating Manual Expanded Edition (courtesy of W5JCK) Page 46 of 77Standard Memory ScanDuring Standard Memory Scan, scanning will pause on any signal encountered that is strongenough to open the squelch; scanning will then resume according to the Scan-Resume modethat was selected. See Set the Scan-Resume Preference on page 42 for details.To Flag a Memory channel to be Scanned during Standard Memory Scan: This is the default setting, so you only need to complete these steps if youpreviously changed this setting for this Memory channel.1. Set the radio to the Memory mode by pressing the key, if necessary.2. Rotate the DIAL knob to select the channel which you wish to be scanned duringStandard Memory Scan.3. Press the key for ½ second twice to select OFF (skip off) and exit to normaloperation. 0.To configure the FT−8900R for Standard Memory Scan: This is the default setting, so you only need to complete these steps if youpreviously changed this setting. This setting is stored separately for eachside of each Hyper Memory channel (see page 38).1. Press the SET key momentarily to enter the Set mode.2. Rotate the DIAL knob to select Menu #35 SCAN M.3. Press the DIAL knob momentarily, then rotate the DIAL knob to MEM.4. Press and hold in the DIAL knob for ½ second to save the new setting and exit tonormal operation.0.To initiate Standard Memory Scan:1. Configure the FT−8900R for Standard Memory Scan, if necessary.2. Press the key momentarily to initiate Standard Memory Scanning.3. To cancel the Standard Memory Scan, press the key momentarily.0.