Yaesu FT1DR Instruction Manual

Also see for FT1DE: Manual Operating manual Technical supplement Instruction manual Quick manual

Contents

9Connecting to a Faraway Station Using WIRES-X(3) Connected to the local node, successfully connectedto Internet nodes or rooms (nodes or rooms are thesame as ones previously used)䢶䢵䢲䢰䢺䢲䢲䢢䣆䣐䣌䣓䢳䣛䣄䣉䢯䣐䣆䢳䢢䢢䣕䣊䣋䣐䣃䣉䣃䣙䣌䣃䢴䣛䣕䣑䢯䣐䣆䢴䢢䣐䣃䣉䣑䣛䣃(4) Connected to the local node, successfully connectedto Internet nodes or rooms (nodes or rooms aredifferent from ones previously used)䢶䢵䢲䢰䢺䢲䢲䢢䣆䣐䣌䣓䢳䣛䣄䣉䢯䣐䣆䢳䢢䣕䣊䣋䣐䣃䣉䣃䣙䣌䣃䢳䣜䣔䣎䢯䢹䢺䢻䢢䣕䣊䣋䣐䣃䣉䣃䣙When the is displayed, rotate the O. Call signsof nodes or rooms where you previously establishedconnection will flash.䢶䢵䢲䢰䢺䢲䢲䢢䣆䣐䣌䣓䢳䣛䣄䣉䢯䣐䣆䢳䢢䢢䣕䣊䣋䣐䣃䣉䣃䣙䣌䣃䢴䣛䣕䣑䢯䣐䣆䢴䢢䣐䣃䣉䣑䣛䣃Tip While the [X] is flashing, press the % to re-establishconnection to the local node.Tip When any local node cannot be found, [X ] will disappearin 5 minutes.Tip When the detected local node is a repeater station, [[R ]]will appear below [X ]. 䢶䢵䢲䢰䢺䢲䢲䢢䣆䣐䣌䣓䢳䣛䣄䣉䢯䣐䣆䢳䢢䣕䣊䣋䣐䣃䣉䣃䣙CautionWIRES-X can be used only on band A.When using band B (shown on the bottom part of the screen) as the operation band, afterpressing and holding % for 1 second or more, band A (shown on the top part of the screen) willautomatically become the operation band.Connecting to a node or room on the InternetYou can connect to a desired node or room in one of the following ways.• Selecting an accessible node or room from the list• Specifying the node name or room name• Selecting the most recently connected node or room• Specifying the DTMF ID of the desired node or room● Searching from the node & room lists1 When the connection destination is displayed, press andhold H for 1 second or more.The menu list of the local node will appear.䢶䢵䢲䢰䢺䢲䢲䢢䣆䣐䣌䣓䢳䣛䣄䣉䢯䣐䣆䢳䢢䢢䣕䣊䣋䣐䣃䣉䣃䣙