Components23To increase resistance, turn the adjusterclockwise.To decrease resistance, turn the adjustercounterclockwise.WARNINGEWM00040Do not overtighten the friction adjuster. Ifthere is too much resistance, it could bedifficult to steer, which could result in anaccident.EMU26143Power trim and tilt switch on remotecontrol or tiller handleThe power trim and tilt system adjusts theoutboard motor angle in relation to the tran-som. Pressing the switch “ ” (up) trims theoutboard motor up, and then tilts it up. Press-ing the switch “ ” (down) tilts the outboardmotor down and trims it down. When theswitch is released, the outboard motor willstop in its current position.For instructions on using the power trim andtilt switch, see pages 57 and 60.EMU26154Power trim and tilt switch on bottomcowlingThe power trim and tilt switch is located onthe side of the bottom cowling. Pushing theswitch “ ” (up) trims the outboard motor up,and then tilts it up. Pushing the switch “ ”(down) tilts the outboard motor down andtrims it down. When the switch is released,the outboard motor will stop in its current po-sition.For instructions on using the power trim andtilt switch, see page 60.WARNINGEWM01031Use the power trim and tilt switch locatedon the bottom cowling only when the boatis at a complete stop with the engine off.Attempting to use this switch while theboat is moving could increase the risk offalling overboard and could distract theZMU02908
