Yamaha 40V Owner's Manual

Also see for 40V: Owner's manual Service manual Owner's manual Owner's manual Owner's manual

Contents

Yamaha 40V Owner's Manual Manual pdf 72 page image

Maintenance66serviced by an authorized Yamaha dealerprior to storage. However, you, the owner,with a minimum of tools, can perform the fol-lowing procedures.NOTICEECM01411● Do not place the outboard motor on itsside before the cooling water hasdrained from it completely, otherwisewater may enter the cylinder throughthe exhaust port and cause engine trou-ble.● Store the outboard motor in a dry, well-ventilated place, not in direct sunlight.EMU28305ProcedureEMU28335Flushing in a test tankNOTICEECM00301Before starting the engine, make sure tosupply water to the cooling water passag-es. Otherwise, the engine could overheatand be damaged.1. Wash the outboard motor body usingfresh water. NOTICE: Do not spray wa-ter into the air intake. [ECM01840] For fur-ther information, see page 67.2. Disconnect the fuel line from the motoror shut off the fuel cock, if equipped.3. Remove the engine top cowling and si-lencer cover. Remove the propeller.4. Install the outboard motor on the testtank. Fill the tank with fresh water toabove the level of the anti-cavitationplate. NOTICE: If the fresh water levelis below the level of the anti-cavita-tion plate, or if the water supply is in-sufficient, engine seizure may occur.[ECM00291]5. Cooling system flushing is essential toprevent the cooling system from clog-ging up with salt, sand, or dirt. In addi-tion, fogging/lubricating of the engine ismandatory to prevent excessive enginedamage due to rust. Perform the flush-ing and fogging at the same time.WARNING! Do not touch or removeelectrical parts when starting or dur-ing operation. Keep hands, hair, andclothes away from the flywheel andother rotating parts while the engineis running. [EWM00091]6. Run the engine at a fast idle for a fewminutes in neutral position.7. Just prior to turning off the engine, quick-ly spray “Fogging Oil” alternately intoeach carburetor or the fogging hole ofthe silencer cover, if equipped. Whenproperly done, the engine will smoke ex-cessively and almost stall.8. Remove the outboard motor from thetest tank.9. Install the silencer cover/cap of fogginghole and top cowling.10. If the “Fogging Oil” is not available, runthe engine at a fast idle until the fuel sys-tem becomes empty and the engine1. Water surface2. Lowest water levelZMU0205112