Basic components18board motor.NOTE: Memorize the trim angles that work bestfor your boat under different conditions.Adjust the trim angle to the desired usingthe power trim and tilt switch. If the trim angle of your motor exceeds thetrim operating range, the top segment onthe trim meter display will blink.EMU26650Hour meter (digital type)This meter shows the number of hours theengine has been run. It can be set to showthe total number of hours or the number ofhours for the current trip. The display canalso be turned on and off. Changing the display format Pressing the “ ” (mode) button chang-es the display format in the following pat-tern: Total hours→Trip hours→Display off Resetting the trip hours Simultaneously pressing the “ ” (set)and “ ” (mode) buttons for more than1 second while the trip hours are displayedresets the trip counter to 0 (zero).NOTE:The total number of hours the engine hasbeen run cannot be reset.EMU26801Warning systemCAUTION:ECM00090Do not continue to operate the engine if awarning device has activated. Consultyour Yamaha dealer if the problem can-not be located and corrected.EMU26812Overheat warningThis engine has an overheat warning device.If the engine temperature rises too high, thewarning device will activate.Activation of warning device The engine speed will automatically de-crease to about 2000 r/min. The overheat warning indicator will light (ifequipped on the bottom cowling or the ta-chometer).ZMU01869ZMU01870ZMU01757