63P3F11 7-18123456789Removing the clamp brackets1. Remove the power trim and tilt unit. Forremoval procedures, see “Removing thepower trim and tilt unit.”2. Remove the anode.3. Remove the bolt and grease nipples, andthen disconnect the ground leads.4. Remove the self-locking nut and bolt.5. Remove the through tube, then disas-semble the clamp brackets, trim sensorcam, and swivel bracket.6. Remove the trim sensor.7. Remove the tilt stop levers.Installing the clamp brackets1. Install the tilt stop levers onto the swivelbracket assembly.2. Install the trim sensor 1 and bushingsonto the swivel bracket assembly.3. Assemble the clamp brackets, washers,and swivel bracket, and then install thethrough tube.NOTE:• Make sure that the trim sensor cam isinstalled between the swivel bracket holes.• Adjust the trim sensor cam after assembly.4. Install the bolts on the through tube, andthen tighten the self-locking nut to thespecified torque.5. Install the power trim and tilt unit, thenthe anode.NOTE:Install the ground lead between the powertrim and tilt unit and the anode.6. Install the ground lead between theclamp brackets and the swivel bracket.7. Apply water resistant grease through thegrease nipples.NOTE:Apply the grease until it comes out of thebushing a.Adjusting the trim sensor cam1. Fully retract the power trim and tilt unit.2. Loosen the trim sensor cam screw 1.3. Adjust the trim sensor cam 2 where thespecified trim sensor setting resistance isobtained.S60X71401LT271T R..Self-locking nut:15 N·m (1.5 kgf·m, 11.1 ft·lb)S63P7320aAAAAAAClamp brackets
