E3-19ADJUSTING TRIM ANGLE404012*qEMU00951*Manual tilt modelThere are 4 or 5 holes provided in theclamp bracket to adjust the outboardmotor trim angle.1) Stop the engine.2) Remove the trim angle adjusting rod1 from the clamp bracket while tiltingthe motor up slightly.3) Reposition the rod in the desired hole.To raise the bow (“trim-out”), move therod away from the transom.To lower the bow (“trim-in”), move therod toward the transom.Make test runs with the trim set to differ-ent angles to find the position that worksbest for your boat and operating condi-tions.w8 Stop the engine before adjusting thetrim angle.8 Use care to avoid being pinched whenremoving or installing the rod.8 Use caution when trying a trim positionfor the first time. Increase speed gradu-ally and watch for any signs of instabili-ty or control problems. Improper trimangle can cause loss of control.NOTE:The outboard motor trim angle can bechanged approximately 4 degrees byshifting the trim adjusting-rod one hole.
