Instrument and control functions3-233EAU1234JHandlebar switchesLeftRightEAU73020Dimmer/Pass switch “ / /PASS”Set this switch to “ ” for the highbeam and to “ ” for the low beam.To flash the high beam, push the passside “PASS” of the switch while theheadlights are on low beam.TIPThe inside cornering lights come onwith the high beam.EAU12461Turn signal switch “ / ”To signal a right-hand turn, push thisswitch to “ ”. To signal a left-handturn, push this switch to “ ”. Whenreleased, the switch returns to the cen-ter position. To cancel the turn signallights, push the switch in after it has re-turned to the center position.EAU12501Horn switch “ ”Press this switch to sound the horn.EAU54212Stop/Run/Start switch “ / / ”To crank the engine with the starter,set this switch to “ ”, and then pushthe switch down towards “ ”. Seepage 5-2 for starting instructions priorto starting the engine.Set this switch to “ ” to stop the en-gine in case of an emergency, such aswhen the vehicle overturns or when thethrottle cable is stuck.EAU12735Hazard switch “ ”With the key in the “ON” or “ ” posi-tion, use this switch to turn on the haz-ard lights (simultaneous flashing of allturn signal lights).The hazard lights are used in case of anemergency or to warn other driverswhen your vehicle is stopped where itmight be a traffic hazard.NOTICEECA10062Do not use the hazard lights for anextended length of time with the en-gine not running, otherwise the bat-tery may discharge.1. Menu switch “MENU”2. Select switch “ / ”3. Cruise control switches4. Horn switch “ ”5. Turn signal switch “ / ”6. Dimmer/Pass switch “ / /PASS”1. Stop/Run/Start switch “ / / ”2. Drive mode switch “MODE”3. Hazard switch “ ”RESSETPASS165423STOPMODERUNSTART321