INSTRUMENT AND CONTROL FUNCTIONS3-123RightEAU12350Pass switch “ ”Press this switch to flash the headlight.EAU12400Dimmer switch “ / ”Set this switch to “ ” for the highbeam and to “ ” for the low beam.EAU12460Turn signal switch “ / ”To signal a right-hand turn, push thisswitch to “ ”. To signal a left-handturn, push this switch to “ ”. When re-leased, the switch returns to the centerposition. To cancel the turn signallights, push the switch in after it has re-turned to the center position.EAU12500Horn switch “ ”Press this switch to sound the horn.EAU12660Engine stop switch “ / ”Set this switch to “ ” before startingthe engine. Set this switch to “ ” tostop the engine in case of an emergen-cy, such as when the vehicle overturnsor when the throttle cable is stuck.EAU12711Start switch “ ”Push this switch to crank the enginewith the starter. See page 5-1 for start-ing instructions prior to starting the en-gine.EAU44711The engine trouble warning light andABS warning light (ABS model only)may come on when the key is turned to“ON” and the start switch is pushed, butthis does not indicate a malfunction.EAU12733Hazard switch “ ”With the key in the “ON” or “ ” posi-tion, use this switch to turn on the haz-ard lights (simultaneous flashing of allturn signal lights).The hazard lights are used in case ofan emergency or to warn other driverswhen your vehicle is stopped where itmight be a traffic hazard.NOTICEECA10061Do not use the hazard lights for anextended length of time with the en-gine not running, otherwise the bat-tery may discharge.1. Engine stop switch “ / ”2. Start switch “ ”12U39PE2E0.book Page 12 Thursday, November 8, 2012 9:24 AM