PERIODIC MAINTENANCE AND ADJUSTMENT6-396EAU50770Replacing the auxiliary lightbulbIf the auxiliary light bulb burns out, re-place it as follows.1. Remove the headlight unit. (Seepage 6-35.)2. Remove the auxiliary light coupler(together with the socket and bulb)by turning the coupler counter-clockwise.3. Remove the burnt-out bulb by pull-ing it out.4. Insert a new bulb into the socket.5. Install the coupler (together withthe socket and bulb) by turning itclockwise.6. Install the headlight unit.EAU24350Supporting the motorcycleSince this model is not equipped with acenterstand, follow these precautionswhen removing the front and rearwheel or performing other maintenancerequiring the motorcycle to stand up-right. Check that the motorcycle is in astable and level position before startingany maintenance. A strong woodenbox can be placed under the engine foradded stability.To service the front wheel1. Stabilize the rear of the motorcycleby using a motorcycle stand or, ifan additional motorcycle stand isnot available, by placing a jack un-der the frame in front of the rearwheel.2. Raise the front wheel off theground by using a motorcyclestand.To service the rear wheelRaise the rear wheel off the ground byusing a motorcycle stand or, if a motor-cycle stand is not available, by placing1. Auxiliary light coupler11. Auxiliary light bulb2. Auxiliary light bulb socket3. Auxiliary light coupler12 3U39PE2E0.book Page 39 Thursday, November 8, 2012 9:24 AM
