PERIODIC MAINTENANCE AND ADJUSTMENT6-466Engine overheatingWARNINGEWA10400● Do not remove the radiator cap when the engine and radiator are hot. Scalding hot fluid and steam may beblown out under pressure, which could cause serious injury. Be sure to wait until the engine has cooled.● After removing the radiator cap retaining bolt, place a thick rag, like a towel, over the radiator cap, and thenslowly rotate the cap counterclockwise to the detent to allow any residual pressure to escape. When the hissingsound has stopped, press down on the cap while turning it counterclockwise, and then remove the cap.TIPIf coolant is not available, tap water can be temporarily used instead, provided that it is changed to the recommended coolantas soon as possible.Wait until theengine has cooled.Check the coolant level in thereservoir and radiator.The coolant levelis OK.The coolant level is low.Check the cooling systemfor leakage.Have a Yamaha dealer checkand repair the cooling system.Add coolant. (See TIP.)Start the engine. If the engine overheats again, have aYamaha dealer check and repair the cooling system.There isleakage.There isno leakage.U39PE2E0.book Page 46 Thursday, November 8, 2012 9:24 AM
