11 EnConnectionsPREPARATION English■ Connecting speaker cablesSpeaker cables have two wires. One is for connecting thenegative (-) terminal of the unit and the speaker, and theother is for the positive (+) terminal. If the wires arecolored to prevent confusion, connect the black wire to thenegative and the other wire to the positive terminal.a Remove approximately 10 mm (3/8”) of insulation from the ends ofthe speaker cable and twist the bare wires of the cable firmly together.b Loosen the speaker terminal.c Insert the bare wires of the cable into the gap on the side (upperright or bottom left) of the terminal.d Tighten the terminal.■ Bi-wire connectionBi-wire connection separates the woofer from thecombined midrange and tweeter section. A bi-wirecompatible speaker has four binding post terminals. Thesetwo sets of terminals allow the speaker to be split into twoindependent sections. With these connections, the mid andhigh frequency drivers are connected to one set of terminalsand the low frequency driver to another set of terminals.Connect the other speaker to the other set of terminals inthe same way.When making bi-wire connections, remove the shorting bridgesor cables on the speaker. Refer to the speakers’ instructionmanuals for more information.yTo use the bi-wire connections, press SPEAKERS A andSPEAKERS B on the front panel or on the remote control so thatboth SP A and B light up on the front display.Connecting the speakers10 mm(3/8")aabbddccNoteABSPEAThis unitSpeakerSTANDBY/ONVOLUMERETURNPUSH - ENTERTUNINGPRESETFM/AMMEMORYBASS TREBLE INPUTFM MODEDISPLAYSELECTPHONES SPEAKERSA BSPEAKERS A/BSPEAKERS A/BLINE 1COAXIAL OPTICAL NETLINE 2 LINE 3DIMMER SLEEPBASPEAKERS
