Yamaha RX-V365 Owner's Manual

Contents

17 EnOptimizing the speaker setting for your listening room (YPAO)EnglishINTRODUCTIONADDITIONALINFORMATION APPENDIXPREPARATIONBASICOPERATIONADVANCEDOPERATIONNotes• During the automatic setup procedure, do not perform anyoperation on this unit.• We recommend that you get out of the room while this unit is in theauto setup procedure. It takes approximately 3 minutes for this unitto complete the auto setup procedure.6 When all measurements are completedsuccessfully, “FINISH” appears on the frontpanel display.The result of the automatic setup for each speakerappears in order on the front panel display.y• To display the result of the automatic setup again, press lk / nrepeatedly.Notes• If you select “RELOAD” in step 4, no test tones are output.• If an error occurs during the “AUTO:CHECK” procedure, thesetup procedure is canceled and an error screen appears. Fordetails, see “If an error screen appears” on page 17.• When this unit detects potential problems during the “AUTOSETUP” procedure, “WARNING” and the warning messagesappear after this unit displays the result of the automatic setup. Fordetails, refer to the “AUTO SETUP” section in “Troubleshooting”on page 43.• The distance measurement result may be longer than the actualdistance depending on the characteristics of your subwoofer.7 Press ll / h to select “SET” or “CANCEL.”8 Press lENTER to confirm your selection.“AUTO SETUP” appears on the front panel display.9 Press kMENU to exit from “SET MENU.”10 Disconnect the optimizer microphone fromthis unit.The optimizer microphone is sensitive to heat. Keep itaway from direct sunlight and do not place it on topof this unit.y• If you change speakers, speaker positions, or the layout of yourlistening environment, run “AUTO SETUP” again to recalibrateyour system.• When you want to check the result of the automatic setup in detailor manually adjust the parameters, use “MANUAL SETUP” (seepage 31).■ If an error screen appearsIf this unit detects the potential problems, an errormessage appears on the front panel display during theautomatic setup.For details about each error message, see the “AUTOSETUP” section in “Troubleshooting” on page 43.After a few seconds later, the following choices appear.Press ll / h to select “RETRY” or “EXIT” and thenpress lENTER.■ If “WARNING” appearsWhen this unit detects potential problems during theautomatic setup procedure, “WARNING” appears on thefront panel display after result of each speaker. Check thewarning messages to correct your speaker settings.Note• Warnings differ from errors in that warnings do not cancel the automaticsetup procedure.Press ln to display the detailed informationabout the warning.The detailed information about the warning is displayedand the indicators of inapplicable speakers blink on thefront panel display.y• For details about each warning message, see the “AUTO SETUP” sectionin “Troubleshooting” on page 43.Choice FunctionSET* Confirms the “AUTO SETUP” results.CANCEL Cancels the “AUTO SETUP” results.FL: 3.3m +2The distance between the speakerand the listening positionThe result of theadjustment of thevolume levelSpeakerFL/FR: Front left/rightC: CenterSL/SR: Surround left/rightSW: SubwooferChoice FunctionRETRY* Starts the “AUTO SETUP” again.EXIT Exits from the “AUTO SETUP” procedure.PHASE REVERSED LFEL C RSL SRFlashes