Yamaha RX-V365 Owner's Manual

Contents

BEFORE MAKING CONNECTIONS, MAKE SURE THATTHE AMPLIFIER IS SWITCHED OFF.n CONNECTIONS● Connect the screw-type input terminals at the rear of thespeakers to the speaker output terminals of your amplifi-er with the provided speaker cords.● One side of the speaker cord has a gray line. Connectthe (+) terminals on both the amplifier and the speakersusing the side of the cord with the gray line. Connect the(–) terminals on both components using the side withouta gray line.● Connect one speaker to the left (marked L) terminals ofyour amplifier, and another speaker to the right (markedR) terminals, making sure not to reverse the polarity (+,–). If one speaker is connected with reversed polarity,the sound will be unnatural and lack bass.Procedures:À Loosen the terminal knob.Á Insert the bare speaker wire end properly into the ter-minal hole. [Remove approx. 10 mm (3/8”) insulationfrom the speaker cord.]Â Tighten the knob.Ã Test the security of the connection by pulling lightly thecord at the terminal.NoteDo not let the bare speaker wires touch each other asthis could damage the speaker orthe amplifier, or both of them.SPECIFICATIONSType..........................2-way 2-speaker acoustic-suspensionspeaker systemSpeaker Unit ..........................................10 cm cone woofer2.2 cm dome tweeterInput Terminal .....................................................Screw-typeImpedance .................................................................6 ohmFrequency Response ..................................80 Hz – 30 kHzNominal Input Power.....................................................50WMaximum Input Power ................................................150WSensitivity (2.83V, 1m) ................................................90 dBCrossover Frequency ..................................................5 kHzDimensions (WxHxD).......................150 x 265 x 156.3 mm(5-7/8” x 10-7/16” x 6-3/16”)Weight .................................................2.2 kg (4 lbs. 13 oz.)Accessories ..................................Speaker cords (10m) x 2* Specifications subject to change without notice due toproduct improvements.* Care should be taken not to exceed the input power val-ues noted above.CONNECTION TO YOUR AMPLIFIERRed (+)Black (–)Speaker outputterminals of theamplifierLoosenTightenGray lineAmplifierGray line Gray lineSpeaker (R) Speaker (L)