En 30PLAYBACKThe FM/AM tuner of this unit provides the followingtwo modes for tuning.Normal tuningYou can tune in to a desired FM/AM station by searchingor specifying its frequency.Preset tuning (☞p. 31)You can preset the frequencies of FM/AM stations byregistering them to specific numbers, and later just selectthose numbers to tune in.Selecting a frequency for reception(Normal tuning)1 Press cTUNER to switch to the tuner input.2 Press dFM or dAM to select a band toreceive.3 Use dTUNING H / I to set a frequency toreceive.dTUNING HIncreases the frequency. Press and hold this key forlonger than a second to search automatically for a stationon a higher frequency than the current one. J1dTUNING IDecreases the frequency. Press and hold this key forlonger than a second to search automatically for a stationon a lower frequency than the current one. J1FM/AM tuningcTUNERdFMdAMdTUNING H / IiCursor B / C / D / EiENTERlOPTIONOPTIONTUNERFM AMTUNINGENTERRECEIVERSCENESETUPRETURNVOLUMEENHANCER SUR. DECODESTRAIGHTHDMIAVAUDIOTRANSMITSLEEP1 2 3 41 2 3 41 25V-AUXINFO MEMORYPRESETMOVIE MUSIC STEREOBDDVD TV CD RADIOMUTElicdWhen using the FM/AM tuner, adjust the direction ofthe FM/AM antenna connected to this unit to get thebest reception.SWCLSL SRRFM87.50MHzVOL.STEREOTUNEDSWCLSL SRRFM98.50MHzVOL.Lights up when receivinga broadcast from a stationLights up when receivinga stereo broadcast■ When signal reception is poorWhen you are receiving an FM broadcast and cannotobtain a stable stereo broadcast, you can force thisunit to receive in a monaural mode.1 Press cTUNER to switch to the tunerinput.2 Press lOPTION to display the Optionmenu. J23 Use iCursor B / C to select “FM Mode.”4 Press iENTER and use the iCursor D /E to select “Mono.”5 When setting is completed, presslOPTION to close the Option menu.To return this unit to its original settings, use thesame procedure to return the settings to “Stereo.”FMModeOPTION VOL.FMMode:Mono9850 VOL.J 1 : When searching for a station, release the key once the search hasstarted.J 2 : See the section on “Configuring the settings specific for eachinput source (Option menu)” for details on the Option menu(☞p. 34).