Yamaha RX10RTW Owner's Manual

Also see for RX10RTW: Supplementary service manual

Contents

Yamaha RX10RTW Owner's Manual Manual pdf 23 page image

5-5ClockTo set the clock1. Push the “SELECT” button 1 and “RESET” button 2simultaneously until the hour digits start flashing.2. Push the “RESET” button to change the hour setting,and then push the “SELECT” button. The minute dig-its will start flashing.3. Push the “RESET” button to change the minute set-ting, and then push the “SELECT” button. The clockstarts when the “SELECT” button is released.NOTE:@The clock must be set again when the battery is discon-nected.@Display brightness controlThis function allows you to adjust the brightness of themeter display to suit the outdoor lighting conditions.To adjust the display brightness1. Turn the main switch to “OFF”.2. Push and hold down the “SELECT” button 1.3. Turn the main switch to “ON”, and then, after 5 sec-onds, release the “SELECT” button.4. Push the “RESET” button 2 to select the desired dis-play brightness level 3, and then push the “SELECT”button. The normal display returns when the“SELECT” button is released.NOTE:@If the main switch is turned to “OFF” or the engine isstarted before completing the procedure, the setting isnot applied.@ESU00363High beam indicator lightThe high beam indicator light 1 comes on when the highbeams of the headlights are switched on. (See page 5-10for headlight beam switch operation.)E_8gt.book Page 5 Tuesday, March 28, 2006 5:37 PM