6-3ESU04581Engine oil levelThe engine oil level should be checked before each use.CAUTION:@Do not run the engine with too much or not enoughoil in the oil tank. Oil could flow into the air filter caseand the engine could be damaged.@Checking the engine oil level1. Place the snowmobile on a level surface and applythe parking brake.2. Start the engine, warm it up for 10–15 minutes, andthen turn it off.NOTE:@ The engine can also be warmed up by operating thesnowmobile for 10–15 minutes. After operating the snowmobile, allow the engine toidle for at least 10 seconds before turning it off.@3. Remove the shroud and the right side cover. (Seepages 8-5–8-7 for removal procedures.)4. Disconnect the oil level gauge coupler 1.CAUTION:@Disconnect the oil level gauge coupler before remov-ing the oil level gauge/dipstick. Otherwise, the cablecan twist and break.@5. Remove the oil level gauge/dipstick 2, wipe it clean,insert it back into the oil filler hole (without screwing itin), and then remove it again to check the oil level.NOTE:@The engine oil should be between the “H” 3 and “L” 4level marks on the oil level gauge/dipstick.@6. If the engine oil is below the “L” level mark, add suffi-cient oil of the recommended type to raise it to the “H”level mark. (See page 6-2 for the recommended oil.)E_8gt_Preop.fm Page 3 Friday, April 7, 2006 7:16 PM