PRODUCT OVERVIEW24 YM Series Operation ManualSingle-Handle Remote ControlHeadFigure 4Figure 14Note: Direction of travel will varydepending on installationlocation.1 – Low Speed - FWD or REV2 – Low Speed - FWD or REV3 – NEUTRAL - Power to thepropeller shaft is cut off andthe engine idles4 – Maximum Engine Speed - FWDor REV5 – Maximum Engine Speed - FWDor REVA single handle-type (Figure 14) shouldbe used to operate the marine gear clutch(NEUTRAL, FORWARD and REVERSE)and to control the engine speed.The handle controls the direction of theboat (ahead or astern) and also acts as anaccelerator by increasing engine speed asthe control handle is pushed further inFORWARD or REVERSE directions.When the handle is pulled out(Figure 15, (1)), the engine speed can becontrolled without engaging the marinegear. The marine gear remains inNEUTRAL, no loadposition. Turn the knob (Figure 15, (2))counterclockwise to move the handle orclockwise to lock the handle.Figure 15Note: Yanmar recommends the use ofa single-handle type for theremote control system. If only atwo-handle type is available inthe market, reduce enginespeed to 1000 min-1 or lessbefore engaging anddisengaging the marine gearclutch.143 250004504210004511
