User Guide for the CP920 HD IP Conference Phone76Placing CallsYou can tap the off-hook key either before or after entering the number to place a call. You canalso dial an entry from local directory, favorite directory, remote phone book or call history. Formore information, refer to Contact Management on page 40 and Call History Management onpage 55.The call duration and far-site’s information (name and phone number) are visible on the LCDscreen. In the figure below, the call to “Bob” (the phone number: 0217) has lasted 6 seconds.Placing a CallTo place a call:Do one of the following:- Tap to obtain a dial tone.Enter the desired number using the keypad.Tap , , or the Send soft key.- Enter the desired number using the keypad.Tap , , or the Send soft key.The # key is configured as a send key by default. You can also set the * key as the send key, orset neither. For more information, refer to the Key As Send on page 34.NotePlacing multiple callsThe CP920 IP conference phone can handle multiple calls at a time. However, only one activecall (the call that has audio associated with it) can be in progress at any given time.To place multiple calls:You can have more than one call on your CP920 IP conference phone. To place a new callduring an active call, do one of the following:- Tap . The active call is placed on hold.You can also dial using the SIP URI or IP address. To obtain the IP address of a phone, tap theOK key when the phone is idle. The maximum length of SIP URI or IP address length is 32characters. For example, SIP URI: 3606@sip.com, IP: 192.168.1.15 or 192*168*1*15.Your phone may not support direct IP dialing. Contact your system administrator for moreinformation.
