Overview19Two ways to customize configurations of your SIP VP-T49G IP phone: The user interface on the IP phone. The user interface in a web browser on your PC.The hardware components keypad and touch screen constitute the phone userinterface, which allows the user to execute all call operation tasks and basicconfiguration changes directly on the phone. In addition, you can use the web userinterface to access all configuration settings. In many cases, it is possible to use eitherthe phone user interface and/or the web user interface interchangeably. However, insome cases, it is only possible to use one or the other interface to operate the phoneand change settings.You can customize your phone by tapping the Menu soft key to access the phone userinterface. The Advanced option is only accessible to the administrator, and the defaultadministrator password is ―admin‖ (case-sensitive). For more information oncustomizing your phone with the available options from the phone user interface, referto Customizing Your Phone on page 55.In addition to the phone user interface, you can also customize your phone via web userinterface. In order to access the web user interface, you need to know the IP address ofyour new phone. To obtain the IP address, tap Menu->Status on the phone when thephone is idle. Enter the IP address (e.g., http://192.168.0.10 or 192.168.0.10 for IPv4;http://[2005:1:1:1:215:65ff:fe64:6e0a] or [2005:1:1:1:215:65ff:fe64:6e0a] for IPv6) in theaddress bar of a web browser on your PC. The default administrator user name andpassword are both ―admin‖ (case-sensitive).The main options you can use to customize the IP phone via phone user interface and/orvia web user interface are listed in the following table:Options Phone User Interface Web User InterfaceStatus√ √--IP Address--MAC--Firmware--Network--Phone--Accounts