Feature Set Reference200 025-9368HUser RangeUser range sets the user number whose data is currently displayed in the Interconnect User Menu.This command selects the particular user whose data you wish to view or program. This can be asingle user or a block or range of users.Once a user range has been selected, it remains unchanged until you exit or terminate theprogramming session. This means you can set User range to the desired user, and go back to anothermenu to verify or change a setting. When you return to the User Menu, it will display the same user.The User range may be set to anything, as long as the starting and ending users are within thespecified range (1-154) and the starting user number is lower than the ending user number.To select a single user, enter the user number at the prompt for “Starting user” and press ENTER. Atthe second prompt “Ending user” just press ENTER. The Repeater Panel User Menu will be re-printed with the selected user's data.To select a range or block of users, enter the lower user number at the prompt for “Starting user” andpress ENTER. At the second prompt “Ending user”, enter the higher user number and press ENTER.The Interconnect User Menu will be re-printed using the “Starting user” data.B LOCK OR R ANGE PROGRAMMING: The Model 748 supports block or range programming of mostitems in the User menu. You can set them one at a time or set the whole block or range with thesame setting.When you have a range of users specified and select a command that supports block programming,the Model 748 will prompt you as to whether you want to program all of them (in the user range) inone keystroke, or if you would like to review and alter each of them individually. If you elect to letthe Model 748 program them all without reviewing them, it will change all of the users in the userrange and give you a prompt when it is finished. If you would like to program a certain parameter fora range of users, but you want them to be different, the Model 748 will show you each user one-at-a-time and allow you to change each independently from the other users. If you decide you don't wantto continue, press CTRL-C to abort.The user that is displayed is the first user in the range. This user is called the “current user”. If youexecute a command that can only be programmed one user at a time, only the current user will bechanged.How to program it:Access the Model 748 through your direct connected PC or terminal, or remotely from your PCconnected to a modem via the Model 748's internal modem.Once connected to the Model 748 and the Main Menu is on the screen, type “2” and press ENTER,and the Repeater Panel Menu will appear. Type “2” and press ENTER, the Repeater Panel Usermenu will be displayed using the currently selected user's data. Select the item number for Userrange and press ENTER. The current starting user number will be displayed, along with a promptinstructing you to enter a starting user number. Type the first user number you wish to program andpress ENTER. The ending user number will then be displayed, along with a prompt instructing you
