Zeiss OPMI Lumera i Instructions For Use Manual

Device overview OPMI Lumera iVersion 8.0Page 34 G-30-1720-enSystem overviewThe OPMI Lumera i comprises the following key components:1 Microscopefor the magnified visualization of the field of view.2 X-Y couplingfor precise movement of the microscope in the horizontal X-Y plane.3 Standfor powering and controlling the functions of the surgical microscope.The floor stand comprises the suspension and carrier arms, the standcolumn, and the stand base.The carrier arm contains the control unit with all electrical supply systemsrequired for the control of the motorized microscope.The suspension arm allows the surgical microscope to be positioned orbrought into its standby position (suspension arm in upward position).The light turns off in the standby position, and functions like XY or FocusReset are reset to their stored start value. The downward travel of thesuspension arm can be limited as required.A maneuvering handle mounted on the stand column is used to move thestand and to attach the foot control panel. The stand column is equippedon both sides with cable holders for winding up the cables before movingthe device to another location.The stand base is equipped with four steerable casters which make it easierfor you to position the system in the OR. The locking tabs of the castersenable you to prevent the system from moving or rolling away of its ownaccord.4 Foot control panel (not shown in the illustration)for controlling the major motorized functions of the microscope.