Zenith H27C46DT Installation & Operation Manual

P A G E 1 7206-3602Mini glossary75 OHM RF CABLE The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wiresticking through the middle, and it screws onto the threaded jack on the back of your TV.A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screwson one end and a round opening with a wire sticking out on the other end.Hook Up Your Antenna to the TVConnect an off-air antenna to the Presentation TVIf you have a 75 ohm RF cable, then youdon’t need any adapters!A 300 to 75 ohm adapter is not included withthe Zenith Presentation TV.300 TO 75 OHMADAPTERTV backVIDEOANTENNACABLER- AUDIO- LS-VIDEO INCOMPUTERAUDIORLAUX INM.P.I. R- AUDIO- LR- AUDIO- LS-VIDEO OUTCOMPUTERINAUDIO OUTFlat wire(300 ohm)Antenna300/75 ohmAdapterRF coaxial wire(75ohm)AntennaTV backVIDEOANTENNACABLER- AUDIO- LS-VIDEO INCOMPUTERAUDIORLAUX INM.P.I. R- AUDIO- LR- AUDIO- LS-VIDEO OUTCOMPUTERINAUDIO OUTLocate the Antenna/Cable jack on the back of thePresentation TV.Connect the cable that runs from the wall directly tothis jack, according to the diagram to the right.Remove the back of the remote and put in two AAAbatteries.Plug in your TV. Do not plug it into a switched out-let. Your Entertainment Machine is designed to oper-ate on standard current, 120-volt 60 Hertz AC. Donot attempt to operate it on DC Current.Go to page 23 to Auto Program your Presentation TV.back ofremote12345