Zenith H27C46DT Installation & Operation Manual

P A G E 4 2 206-3602-OPRG POWERCABLE VCR AUX TVSURFENTERFLASHBK MUTECHANNELCHANNELVOLUME VOLUME1 2 34 5 6708 9MENUREWIND FFWDRECORDQUITABCCCTV/VCRSOURCEPAUSE TIMERPLAYSTOP5/73624Indicator LightRemote Control Auto-FindTurn on the device you’re programming for theremote control.Press and hold the PRG key until the indicator lightturns on.Press the key for the device you’re trying to program(CABLE, VCR, AUX, TV).Enter the code 0-0-0 (zero-zero-zero), then press theENTER key right away.Aim the remote at the correct device and pressPOWER. Allow a second to pass, then push thePOWER key again. Repeat until the device turns off.(This is a trial and error process, so it may be neces-sary to repeat these steps until the remote finds yourcode.)Push ENTER to save the code.Press POWER to turn the device back on.1234567You can quickly get out of Auto Find by pressing QUIT.If the indicator light stays on while you push Power, insteadof turning off, all the codes have been tried and the devicecan’t be programmed.If Programming the Remote did not find your code, try this procedure to automatically findthe code for your device. If your remote becomes inoperable, go back to “Programming yourRemote” and enter the Zenith TV code for step five