Zenith System 3 Operating Manual & Warranty

Also see for SYSTEM 3 Series: Operating guide & warranty Operating guide and warranty Operating guide & warranty Operating guide

OPERATING YOUR TVfBASIC TV OPERATIONSSelecting Channels by Using CHANNEL (CH) Up/Down:You may select a channel through channel scanning by usingCHANNEL (CH) Up/Down. Only channels stored in thechannel scan sequence can be selected.Selecting Channels by Using Numbers on Remote: Pressthe numbers corresponding to the channel desired, thenpress ENTER (ENT). Any channel in the band chosen canbe selected through direct number entry.FLASHBK (Flashback) on Remote: Press FLASHBK toreturn to the last TV channel you were watching.Adjusting Volume: You can adjust the volume of your TVby using VOLUME (VOL) Up/Down.Muting Volume: To mute the sound coming from your TV,press MUTE on the remote control. To restore sound,press MUTE again.After an Extended Power Outage: If you previously usedAUTO CH. SEARCH, you do not have to use it again un-less you permanently changed the connections to the TV.All of the channels previously found are stored in protectedmemory, and are not affected by a power outage. However,the clock must be reset to the current time.CH2STEREOChannel/Audio Display(Before Clock is Set)CH210:.56MUTEDJChannel/Time DisplayWhile TV is MutedMUTEDCH210:56STEREOChannel!Time!Audio Display(After Clock is Set)VOLVolume Display *VOL or MUTED display isshown only when captious arenot being displayed.Mute Display *SLEEP TIMERSome remote controls are equipped with a TIMER buttonthat provides access to the SLEEP TIMER available withsome TV mddels. By using the SLEEP TIMER, you canprogram the TV to automatically shut off after a 15 minuteperiod up to 4 hours.To Set SLEEP TIMER1. Press TIMER to see status display.2. Press TIMER repeatedly until you reach desiredshut-off time.One minute before the TV shuts off, the GOOD NIGHTdisplay appears on the screen. At this time you have achoice of the following three actions.1. Do nothing. The TV will shut off in one minute. Thedisplay will count off the remaining seconds.2. Remove the GOOD NIGHT display by pressingENTER (ENT). The TV will still shut off in oneminute.3. Delay the shut off by using TIMER to select a newshut off time.To Cancel the SLEEP TIMERYou can cancel the SLEEP TIMER by setting the SLEEPTIMER status to OFF. Press TIMER repeatedly until OFFstatus appears.NOTE: The SLEEP TIMER resets to OFF when you turnoff the TV." SLEEP TIMER0:15Sleep Timer DisplayV SLEEP TIMER -_GOOD NIGHT0:58"Good Night" Display2577_ 3 - 1