Zenith System 3 Operating Manual & Warranty

Also see for SYSTEM 3 Series: Operating guide & warranty Operating guide and warranty Operating guide & warranty Operating guide

REMOTE CONTROL MBR3420PREPARATION FOR USEBatteries are provided with this remote, but you must installthem before using the remote.INSTALLING BATTERIESWhen the effective operating range of your remote becomesnoticeably shorter, replace the batteries with two (2) highquality, alkaline, size AAA batteries. Do the following:1. Remove the battery compartment cover by PUSH-ING DOWN tab and PULLING OUT from top.2. Insert new batteries as indicated in the diagraminside the compartment. Observe proper batterypolarity.3. Replace the cover by inserting the tab on the bottomof the cover into its housing. Snap the cover intoposition.4. After installing new batteries, the remote controlwill set itself to Zenith brand codes, as follows:TV = 101, VCR = 201 and CABLE = 301.If you are going to operate equipment that usesdifferent codes, the remote must be reprogrammedfor those codes. Refer to "Programming the RemoteControl" section for programming information.CAUTIONS:• Do not place heavy objects on top of the remote controlbuttons. Prolonged accidental operation of the remotecontrol will shorten battery life.• If you are not going to use the remote control for a monthor more, remove the batteries. Battery leakage can causedamage to the remote control.• Zenith is not responsible for damage caused by suchbattery leakage.Re e 1_-o 5 -- 5