ON-SCREEN MENUSSUMMARY OF MENU ITEMS (CONTINUED)SOURCE MenuANT/CABLE: Selecting ANT/CABLE routes the AN-TENNA/CABLE source to the TV for viewing. You seeprogram material from the signal source that is con-netted to the ANTENNA/CABLE jack on the back ofthe 'IV.Selecting VIDEO 1: Routes the VIDEO 1 source to theTV for viewing. You see program material fromthe signal source that is connected to the VIDEO 1,VIDEO/AUDIO LEFT-RIGHT jacks on the back ofthe TV.Selecting VIDEO 2: Routes the VIDEO 2 source to theTV for viewing. You see program material from the sig-nal source that is connected to the VIDEO 2,VIDEO/AUDIO LEFT-RIGHT jacks on the back ofthe TV.BASIC MENU OPERATIONSVertical Control PanelShown1. To See a Menu or Change MenusPress MENU repeatedly until the desired menu isshown. Example shows choosing the SETUP Menu.SETUP MENU* AUTO CH. SEARCHCH. ADD/DELCH. LABELSTUNING BANDAUTO RNE JUNECLOCK SETC,_J=rl]ONSCH. BACKGROUNDSTART2. To Select an Option/Feature on a MenuPress SELECT (SEL) repeatedly until the desiredoption/feature is highlighted. The following ex-ample shows selecting TUNING BAND.SETUP MENUAUTO CH. SEARCHCH. ADD/DEL•'_ TUNING BANDAUTO RNE ]LINECLOCK SETCAPTIONSCH. BACKGROUNDBROADCASTo1.Selecting Tuning BandTo Adjust an Option/FeaturePress ADJUST (ADJ) Left/Right to see and choosethe available selections.NOTE: Do not change channels during menuoperations unless instructed to do so in the proce-dures given in this operating guide.To Access a Different Main MenuPress MENU repeatedly until thc desired menu isshown.To Return to Normal ViewingPress ENTER (ENT) or wait a few seconds and theTV will return automatically to normal operation.Service Menus: In addition to the menus shown above,there are menus for factory and field servicing. Servicemenus are not intended for use by the owner.If you inadvertently access a service menu, press ENTER(ENT) to return immediately to normal TV viewing.Choosing Setup Menu2577-0 6 -- 2