Zitzi Guppy User Manual
                                        | |
Contents
| 
User manual - Zitzi Guppy I 21© Anatomic SITT ABFootrestMounting of footrestAdjusting the angle on the knee-jointSafety stopAdjustment the height of the footrestInsert the footrest attachment (A) in the front holes underneath the seatplate.There is two positions for depht adjustment. Tighten the screws (B) on bothsides with washer and nuts (C).When the footrest attachment is installed to the chassis you can adjust thefootrest angle at the knee-joint. Loosen the screw (E) slightly and adjust to thedesired angle. Tighten the screw.A pin (D) is installed in the bottom of the footrest attackment. The pin can alsobe used to find back to a pre-set height position.When the footrest attachment is installed to the chassis you can adjust the heghtof the footrest. Loosen the adjuster (F) and adjust to required height. Tighten theadjuster.Tips!Install an additional pin above the footrest in the footrest attachment to easilyfind your way back to an alternative height position (eg with or without shoes).Note!Before installation you have to remove the seal from the seatplates. Then youcan easily insert the footrest attachment.DFABEC |
Related manuals for Zitzi Guppy
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine