We reserve the right to make changes26General SettingsInstallerSuperuserUser selection programmesYou can select one of two user selection programmes to override Compact P using an external signal.• User programmes 1• User programmes 2 - User selection 2 has the highest priority and can transmit an output signal.User programmes are set in the Settings menu:• CP/User selection programmes You can programmeChoose which user choices are to be programmed.Indication of start time applies to all settings.This is the time that the programme starts, and it runs to thenext change in the weekly schedule.There are four basic settings in the weekly schedule:1. AutomaticSetpoint (°C) Room temperature (ventilation)SHW setpoint (°C) Hot water production temperatureFan setting Ventilation step2. Night-time dropNight setback temperature is set (see page 16)SHW setpoint (°C) Hot water production temperatureFan setting Ventilation step3. Fan onlySHW setpoint (°C) Hot water production temperatureFan setting Ventilation step4. OffSystem is OFF Compact P(Ventilation and hot water)Display settingsThe control panel is set in the Settings menu:• General Settings/Buzzer mode, ON/OFF You can switch key beeps on or off.• General Settings/Display/Light intensity (%) You can adjust the display light intensity.• General Settings/Display/Display time out (min) You can adjust the interval before the display revertsto standby.The settings in the User selectionprogrammes are the same as in theweekly programme, with one exception.It is possible to select Fan high priority.This is e.g. used on connecting a cookerhood. It will then have higher prioritythan low humidity or low ventilation ata low outdoor temperature.