100 Network File TransfersGigabit Ethernet HardwareA Gigabit Ethernet connector (RJ-45) labeled NET-1 is located on the rear panel for conventionalnetwork access. No hardware settings are available or needed, as Gigabit Ethernet automaticallynegotiates port speed. Connection speed is shown by LEDs on the network connector. The NET-1port also automatically configures transmit and receive connections, and does not need a“crossover” cable when connecting directly from one server to another.Redundant Server ConnectionThe Gigabit Ethernet port labeled NET-2 on the Image Server is reserved for future use and iscurrently not active. No connection should be made from it to other equipment.Gigabit Ethernet Cable QualityThe high data rates generated by Gigabit Ethernet require high-quality cable designed for thisapplication. Low-quality network cables can result in high error rates and lower transmissionspeed. For Gigabit operation, standard CAT-5 cable should not be used.New Category 5e (enhanced) cables ensure maximum transfer rates, and should be used as theminimum standard. Category 6 cable is a more recent product designed for applications wherelonger cable runs are required.Configuring Network SettingsThe Image Server provides a number of user settings that configure it for use as a practical network.These will be found on the GUI System Network tab shown below.The NET-1 Ethernet port on the Image Server has a unique IP Address. In this way, each ImageServer can be identified on the network. It also means that there is only one IP Address for a givenvolume of data.
