2 INSTALLA TION AND SETUP FORMANAGEMENTSafety InformationWARNING: Please read the following safety information beforeinstalling the Management Module or Advanced RMON Module.Installation and removal of either Module should be carried out byqualified personnel only.Read and follow the Safety Information for the installation and removalof the SuperStack II unit. This can be found in the user manual for theunit.You must disconnect all the units in the stack from the mainspower supply before installing the Module.The Modules contain static-sensitive components that can beirreparably damaged by static generated by the human body. Do nottouch the components on the circuit board. Ensure that you onlyhandle the Module by holding it by the edges. We recommend thatwherever possible you use a wriststrap or other earthing method whilstinstalling or removing the Module, to prevent damage by staticdischarge.Installing the Management or Advanced RMON ModuleWARNING: You can only install the Hub 10 Management Module orAdvanced RMON Module in a Hub 10 or LinkBuilder FMS II unit. If youattempt to install either Module into a LinkBuilder FMS unit, you willdamage both products. The section “SuperStack II Hub 10 Management