3-10 CHAPTER 3: USING THE VT100 MA NAGEMENT INTERFACEDUA1663-0BAA03Auto LogoutThere is a built-in security timeout on the VT100 interface. If you do notpress any keys for three minutes, the management facility will warnyou that the inactivity timer is about to expire. If you do not press a keywithin 10 seconds, the timer will expire and the screen will be locked.(Any displayed statistics will continue to be updated, however.) Whenyou next press any key, the display changes to the Auto Logout screen.This screen is shown below.Figure 3-5 Auto Logout ScreenThe Auto Logout screen requests you to enter your password again. Ifthe password is correctly entered, the screen that was active when thetimer expired is re-displayed. If you make a mistake in entering yourpassword, you will be returned to the Logon screen.SetupYou use the Setup screen to configure IP, IPX and SLIP parameters forthe stack. This screen also provides access to other screens for you toset up traps and serial port parameters.3Com SuperStack II Auto LogoutAuto Logout in Progress. Re-enter Password...User Name:Password:security[ ]OK CANCEL
