1-5z When the rate or duplex mode of a port in the aggregation group changes, packet loss may occuron this port;z When the rate of a port decreases, if the port belongs to a manual or static LACP aggregationgroup, the port will be switched to the unselected state; if the port belongs to a dynamic LACPaggregation group, deaggregation will occur on the port.Aggregation Group CategoriesDepending on whether or not load sharing is implemented, aggregation groups can be load-sharing ornon-load-sharing aggregation groups. When load sharing is implemented,In general, the system only provides limited load-sharing aggregation resources, so the system needsto reasonably allocate the resources among different aggregation groups.The system always allocates hardware aggregation resources to the aggregation groups with higherpriorities. When load-sharing aggregation resources are used up by existing aggregation groups,newly-created aggregation groups will be non-load-sharing ones.Load-sharing aggregation resources are allocated to aggregation groups in the following order:z An aggregation group containing special ports which require hardware aggregation resources hashigher priority than any aggregation group containing no special port.z A manual or static aggregation group has higher priority than a dynamic aggregation group (unlessthe latter contains special ports while the former does not).z For aggregation groups, the one that might gain higher speed if resources were allocated to it hashigher priority than others. If the groups can gain the same speed, the one with smallest masterport number has higher priority than other groups.When an aggregation group of higher priority appears, the aggregation groups of lower prioritiesrelease their hardware resources. For single-port aggregation groups, they can transceive packetsnormally without occupying aggregation resourcesA load-sharing aggregation group contains at least two selected ports, but a non-load-sharingaggregation group can only have one selected port at most, while others are unselected ports.
