1-19Configuration examplez Configure port rate limiting for inbound packets on Ethernet 1/0/1.z The rate limit is 1,024 KbpsConfiguration procedure: system-view[Sysname] interface Ethernet 1/0/1[Sysname-Ethernet1/0/1] line-rate inbound 1024Configuring Traffic RedirectingRefer to section Traffic Redirecting for information about traffic redirecting.Configuration prerequisitesz The ACL rules used for traffic classification are defined. Refer to the ACL module of this manual forinformation about defining ACL rules.z The traffic redirecting destination is determined.Configuration procedureYou can redirect all the packets matching specific ACL rules, or packets that match specific ACL rulesand are of a VLAN, or pass a port.Table 1-19 Redirect all the packets matching specific ACL rulesOperation Command DescriptionEnter system view system-view —Configure trafficredirectingtraffic-redirect inbound acl-rule { cpu | interfaceinterface-type interface-number } RequiredTable 1-20 Redirect packets that are of a VLAN and match specific ACL rulesOperation Command DescriptionEnter system view system-view —Configure traffic redirectingtraffic-redirect vlan vlan-id inboundacl-rule { cpu | interface interface-typeinterface-number }RequiredTable 1-21 Redirect packets passing a port and matching specific ACL rulesOperation Command DescriptionEnter system view system-view —Enter Ethernet port view interface interface-type interface-number —Configure traffic redirecting traffic-redirect inbound acl-rule { cpu |interface interface-type interface-number } Required
