2-3z The operation of enabling/disabling a VLAN’s VLAN interface does not influence the physicalstatus of the Ethernet ports belonging to this VLAN.z An Switch S4210 can be configured with a single VLAN interface only, and the VLAN must be themanagement VLAN. For details about the management VLAN, refer to the “Management VLANConfiguration” part of this manual.Displaying VLAN ConfigurationTo do... Use the command... RemarksDisplay the VLAN interfaceinformationdisplay interface Vlan-interface[ vlan-id ]Display the VLAN information display vlan [ vlan-id [ to vlan-id ] | all |dynamic | static ]Available in anyview.Configuring a Port-Based VLANConfiguring an Access-Port-Based VLANThere are two ways to configure Access-port-based VLAN: one way is to configure in VLAN view, theother way is to configure in Ethernet port view.Follow these steps to configure the Access-port-based VLAN in VLAN view:To do… Use the command… RemarksEnter system view system-view —Enter VLAN view vlan vlan-idRequiredIf the specified VLAN does not exist, thiscommand be created first creates theVLAN before entering its view.Add an Access port tothe current VLAN port interface-listRequiredBy default, system will add all ports toVLAN 1.Follow these steps to configure the Access-port-based VLAN in Ethernet port view:To do… Use the command… RemarksEnter system view system-view —Enter Ethernet port view interface interface-typeinterface-number —Configure the port link type asAccess port link-type accessOptionalThe link type of a port is Accessby default.
