Displaying and Debugging a VLAN 59You can also move the CPU ports out of/into all the VLANs at a time.Perform the following configuration in system view.Displaying andDebugging a VLANAfter the above configuration, execute the display command in any view todisplay the running of the VLAN configuration, and to verify the configuration.VLAN ConfigurationExampleNetwork requirements■ Create VLAN 2 and VLAN 3.■ Add Ethernet3/1/1 and Ethernet4/1/1 to VLAN 2.■ Add Ethernet3/1/2 and Ethernet4/1/2 to VLAN 3.Network diagramFigure 11 Network diagram for VLAN configurationTable 44 Move the CPU port out of/into the specified VLANsOperation CommandMove the CPU port out of the specifiedVLANs trap-to-cpu disable vlan { vlan-list | all }Move the CPU port into the specifiedVLANs undo trap-to-cpu disable vlan { vlan-list | all }Table 45 Display and Debug a VLANOperation CommandDisplay the related information about theVLAN interface display interface vlan-interface [ vlan-id ]Display the related information about theVLANdisplay vlan[ vlan-id to vlan-id | all | static |dynamic ]Display the protocol information and protocolindex configured on the specified VLAN display protocol-vlan vlan { vlan-list | all }Display the protocol information and protocolindex configured on the specified portdisplay protocol-vlan interface {interface-list | all }Display information about CPU port in a VLAN display trap-to-cpuVLAN 3SwitchE3/1/2E4/1/1VLAN 2E4/1/2E3/1/1
