798 CHAPTER 69: DEVICE MANAGEMENT boot bootrom boot.app slot 0# Use the boot boot-loader command to specify the downloaded program asthe application at the next login and reboot the switch.boot boot-loader primary flash:/switch.app slot 0disp boot-loaderThe primary app to boot of slot 0 at the next time is: flash:/switch.appThe backup app to boot of slot 0 at the next time is: flash:/switch.appThe app to boot of slot 0 at this time is: flash:/switch.appUsing the Switch as anFTP Server to Implementthe Remote Upgrade(Switch 8807)Network requirementsThe switch serves as an FTP server and the PC as an FTP client. The configurationon the FTP server is as follows: an FTP user is configured with the name switch, thepassword hello and the read & write authority over the root directory of theswitch. The IP address of a VLAN interface on the switch is 1.1.1.1, and the IPaddress of the PC is 2.2.2.2. The switch and PC are reachable with each other.The switch application switch.app is stored on the PC. Using FTP, this file can beuploaded from the PC to the switch remotely, and the configuration file vrpcfg.txton the switch can be downloaded to the PC as a backup.Network diagramFigure 186 Network diagram for FTP configurationConfiguration procedure1 Configure the switch# Log into the switch through the console port locally or through telnet remotely(refer to the getting start module for details about the login modes).# Enable FTP on the switch; configure a username, password and path.[SW8800] ftp server enable[SW8800] local-user switch[3Com-luser-switch] service-type ftp ftp-directory flash:[3Com-luser-switch] password simple hello2 Run the FTP client program on the PC to set up an FTP connection with the switch.Then upload the switch program switch.app to the flash root directory on theswitch and download the configuration file vrpcfg.txt from the switch. The FTPclient program is not provided along with the switch, so, it is for you to purchaseand install it.Switch PCNetworkSwitchSwitch PCNetwork
