716 CHAPTER 59: NETSTREAM CONFIGURATIONaggregation log. The eleven aggregation modes are independent of each other, sothey can be configured at the same time.n ■ The configuration in system view affects version 5 UDP packets. Additionally,this configuration is also effective for version 8 UDP packets when the sourceport and destination address arguments are not configured in aggregationview.■ The configuration in aggregation view affects version 8 UDP packets only.c CAUTION: When the aging time is configured, the active aging time is in minutesand the inactive aging time is in seconds.NetstreamConfigurationExamplesNetwork requirementsAs shown in Figure 169, Netstream is configured on Switch A to perform statisticson the packets received on GigabitEthernet3/1/3. The NMM Application Moduleto implement the Netstream function is plugged in slot 5 of the switch.Network diagramFigure 169 Diagram for 3Com Switch 8800 Family Netstream ConfigurationConfiguration procedure# Configure the VLAN of GigabitEthernet3/1/2.system-view[Switch_A] vlan 2[Switch_A-vlan2] port GigabitEthernet3/1/2[Switch_A-vlan2] quit# Configure the IP address for the VLAN interface.[Switch_A] interface vlan-interface 2[Switch_A-vlan-interface2] ip address 12.110.2.1 24[Switch_A-vlan-interface2] quit12.110.2.2GE3/1/2NetworkSwitch ANetworkNetworkNetworkGE3/1/312.110.2.2GE3/1/2NetworkSwitch ANetworkGE3/1/3GE3/1/2NetworkSwitch ANetworkNetworkNetworkGE3/1/3 NetworkData Collector12.110.2.2GE3/1/2NetworkSwitch ANetworkNetworkNetworkGE3/1/312.110.2.2GE3/1/2NetworkSwitch ANetworkGE3/1/3GE3/1/2NetworkSwitch ANetworkNetworkNetworkGE3/1/3