3Com AccessBuilder 4000 Installation Manual

Also see for AccessBuilder 4000: Installation guide

Contents

C-4 APPENDIX C: INSTALLING I/O CARDSInstallationOverviewAll of the I/O cards are installed in either Slot 1 or Slot 2, below themain processor board. The installation procedures for all cards isbasically the same and involves these steps:n Removing the card from its protective bagn Removing the filler panel over the desired card slotn Inserting the card into the slot so it connects with the backplanen Fastening the card to the backplanen Connecting the I/O card connections to the network or modem(s)InstallationProcedureTo install an I/O card:1 Remove the card from its antistatic bag.Do not touch pins, leads, or solder connections on the card. Handle thecard by the edges only.2 Inspect the card for shipping damage.If you find any damage, contact the shipping company to file a report.If the I/O card must be returned to the factory, ship it in the originalshipping carton and antistatic bag. If the original carton was damagedin shipment, repack the card in a carton that provides equivalentprotection.3 If you have not already done so, write down the serial number shownon the component side of the card.You will need this information if you have to contact your supplier for areplacement.4 Select a slot for the I/O card, either slot 1 or 2.5 Remove the face plate from the slot you have selected.To remove the plate, loosen the captive screws and slide the face plateaway from the slot, as shown in Figure C-4.ab4kbook Page 4 Thursday, March 27, 1997 11:51 AM