11-8 C HAPTER 11: D IAL SECURITYWhat the GuestUser Needs to DoWhen guest users want to call in to the host (assuming you have enableDial Security by entering ATS53.0=1), They must know the password. If you have enabled Dialback, they must set their device toauto-answer.1 If the host has security enabled, get a password from the host’sadministrator. The password is case-sensitive, so be sure to copy itcorrectly.If the host has prompting enabled and the host operator enables Dialbackfor your account, skip to Step 3.2 For guest users with Courier V.Everything modems (or I-Modems) only:a Create a security account using the password the host’s administratorasked you to use. (See Setting Up Dial Securit , earlier in this chapterfor instructions.b You need to assign the password as your Autopass passwordExample: Sending AT%V=PW3 will assign the password as an Autopasspassword for account 3.c Check to see that you set your Autopass password correctly by usingthe ATI10 command.Your Autopass password appears beside AUTOPASS PASSWORD, ifyou have done all the steps correctly.d Once the Autopass password is set, enable your Courier V.Everythinmodem’s Dial Security.CAUTION: If you do not follow an S-Register setting with &W, thesetting will be retained only until the next reset or power off.For your modem to CommandAssign the password as yourAutopass passwordAT%V=PWn, where n is the number ofthe account you set up.For your modem to CommandEnable Dial Security ATS53.0=1
